The way I construct the board is a little time consuming but I really enjoy making surfboards. The way I make boards are what’s known as the strip plank style where I put anywhere between 1/4 of an inch to a 1 inch wide board that is a quarter of an inch thick and I use a nose and Cove router bit to allow for a positive placement between the boards, as their bending, and curving over the spine and rib frame. It is it going from a complete unknowing amateur to someone who knows what they’re doing as a serious hobby, and knows how to problem solve and make needed adjustments to issues that arise in the board making process. ĭiscovering and using your program has taken my board making skills to a whole different level. The boards that I’m currently working on our typical small board shapes thrusters anywhere from 7’4” down as small as 5’10”. After I design everything on the AKU program I then export it to the hollow wooden board, template maker, software program, and print out the pattern for the spine and ribs. I use the AKU shaper program to design the layout rocker and where the ribs are going to be placed using the slices program. I’ve gotten much better at reducing the weight by using a thinner cloth and I’m now using the FCS II fin system. Software notes are displayed in this panel in the dimensions tab.I’ve been making hollow wooden surfboards for the last six years and over the last two. Liters will adjust automatically when dimensional changes are made.įor a detailed explanation of volume and how to use this measurement in your shaping, please review this article: Display Notes Volume/Liters are displayed in the dimensions tab. For more precise rocker adjustments, toggle between the top and bottom tabs until desired rocker is achieved. *Tip: When adjusting nose and tail rockers, use the N tool, T tool to move the entire nose or tail rocker. Dimensions are displayed for reference purposes. Tail Rocker: Tail rocker is measured the same way as nose rocker. For more information on nose rockers, please visit here: Rockers - A beginners guide to board building The rocker is measured from the bottom plane of your design to the bottom tip of the board. Nose Rocker: Nose rocker dimensions are displayed here. Thickness can be increase at any point on your design, we list the 1' measurements for reference. Thickness adjustments can also be made in the top/bottom tabs. Thickness 1' from the nose and tail are displayed. Thickness: Thickness measurements are displayed here. To increase/decrease the width at the nose and tail, use the control points. Width: Width measurements are displayed for center, 1' from the nose, and 1' from the tail of your design. Select Straight line or Over the Curve.Īuto Adjust: Auto adjusting slices and rocker/thickness is used to scale an existing shape without the need to reshape the rails or change the rocker due to a change in the dimensions Input your desired dimensions using a decimal or fraction. Length/Pencil Key: Use this key to change the dimensions of your design We provide both options based on your previous shaping style. Over the Curve: Over the curve measurements account for the increased length due to the curve of the rocker.ĭetermining whether to use straight line versus over the curve is a shaper preference. Straight Line: Straight line measurements are taken from tip to tip of a surfboard, not accounting for increased length due to the rocker of a blank or design How to: Change dimensions Startup Guide on how to use the AkuShaper Dimensions Panel Straight Line versus Over the Curve
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |